Search the Community

Showing results for tags 'webserver'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Hello, I have been successful in running the lwIP echo server on the Zybo Z7 board. However, I want to develop a web server on Zynq. I have gone through the lwIP documentation. However, in the discussion of this topic, I was successful in reading the .bin file from the SD card. Now I want to set up a web server on Zynq so I can command the server to read the .bin file from SD card and store it in the DDR. How do I start working on the web server. I have been searching a lot for the tutorial or anything that could make me understand in a simpler way but I failed to find any.!
  2. Hello, I am working on the Zybo-Z7-10 development board, I want to establish a web server application to upload files from my PC and send it to web browser by HTTP POST and extract data inside the file, I am using the lwIP stack and downloaded the xapp1026 files from the gitHub, right now I can run the example application correctly, but I want to change the content inside the image.mfs file provided by the xilinx, I cannot open it, once I open the image.mfs by NotePad, unreadable characters are displayed, I found that at the top of this file, there is a css part, on the bottom of this file I
  3. Dear, At the moment me and and a few friends are testing different IOT's. To upload data from a microcontroller or fpga to a webserver. Or upload to our website with $ comments. So our website will place the value's in the webserver. Now our question is. How can we connect our zybo board to the internet. We know we need to use the ethernet port but its very hard to find any information about uploading data with the zybo board. We use the zybo board with the vivado 2016 version. Greetings, Niels