Search the Community

Showing results for tags 'verify'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hi, I have just received a CMOS S6 evaluation board (410-282P-KIT). Before I program it with my development code I wanted to verify my setup is working Ok. I am using Xilinx 14.7 on a Windows 7 PC. I have loaded iMPACT and successfully initialised the scan chain. I assigned the demo bit file to the FPGA and the demo mcs file to the flash device. When I ask it to iMPACT to verify the contents of the flash memory it fails at address 0. The iMPACT console output is displayed below. INFO:iMPACT - Current time: 11/07/2016 13:18:16 PROGRESS_START - Starting Operation. Maximum TCK operating frequency for this device chain: 25000000. Validating chain... Boundary-scan chain validated successfully. '1': IDCODE is '012018' (in hex). '1': ID Check passed. '1': IDCODE is '012018' (in hex). '1': ID Check passed. '1': Reading device contents... Failed at address, 0 '1': Verification Terminated PROGRESS_END - End Operation. Elapsed time = 1 sec. Is it possible to verify the PROM contents and if so what am I doing wrong? Regards, Stewart.