Search the Community

Showing results for tags 'usb cable for power supply of the board'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Test and Measurement
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Normally I would have had a question for the forum now. However, shortly before sending the question, I found the cause of the problem myself. As it turned out, it is not a problem but only a lack of information about the Vivado development environment. Therefore, here is my question and the direct answer to it. (so that others don't waste their time) The question would have been: I have written a small Verilog description which only flashes one LED. It can be programmed into the board with the USB cable and it works. Then I tried to program this