Search the Community

Showing results for tags 'ttl'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I am trying to use a Pmod485 (P/N 410-310) to connect an Arduino (TTL) to a motor controller (RS485). I am only using 1 Pmod485 and I am assuming I do need to short JP1, is this done just by sliding the blue cap over both pin headers? Also, the IC block diagram shows 2 separate GND (GND1 and GND2) but the module only has 1 GND available on the pin header. Does this mean both GND on the IC are connected together? pmod_pmod_pmodrs485_rm.pdf