Search the Community

Showing results for tags 'sume'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Dear all Unfortunately the SUME card micro USB connector was damaged. Although we tried to solder it again, the board is no longer recognized. I would like to replace the micro USB connector but I could not found any reference of the part number. Could you provide me the part number? or any that could fit to the PCB, since there are many type of micro USB PCB connectors. Best Regards
  2. Hello everyone! I just install a NetFPGA-SUME and I am not sure if it is ok. I followed the getting started guide in https://github.com/NetFPGA/NetFPGA-SUME-public/wiki/Getting-Started-Guide, however, something went wrong apparently... In the Section IV: NetFPGA-SUME First Power Up, I followed the steps, but, after turning on the power switch (SW1) it says I should see Power LED (LD10) and DONE LED (LD4) turn on immediately, however I only see the Power LED (LD10) on... in red. The DONE LED is off. In the next step... When I connect USB to my computer I can see a new USB serial device attached [ 13.194737] usb 3-1: FTDI USB Serial Device converter now attached to ttyUSB1 However, when I try to connect, terminal does not respond (I'm using putty to connect /dev/ttyUSB1). Any clue about what is happening? I tried it with the card connect to my server PCI and also stand alone. Also connecting 2x4 and 2x3 PCI express auxiliary power connectors. Thank you in advaned!
  3. Regis Martins

    power connection.jpg

    From the album: NetFPGA-SUME