Search the Community

Showing results for tags 'spi interface'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Hello, I'm a new user of the digital discovery, which already helped my a lot, but now I'm stuck. In my application I first have to configure a DDS by sending few words by SPI to it, and then I have to read an ADC by SPI. These two devices have separate SPI bus. The DDS is connected like this: nCS = DIO34, SCLK = DIO33, MOSI = DIO35 The ADC is connected like this: nCS = DIO31, SCLK = DIO30, MISO = DIO29 Is there a way by script to first write to the DDS, then reconfigure the SPI protocol pins to connect to the ADC and then read it? Thanks in advance. Best regards Etie
  2. Hello, We are trying to generate the SPI protocols signals from the Zybo-Z710 board, which uses Zynq-7000 SoC. Since, the PS section of the chip contains two SPI modules. Can anyone tells me the procedure for activating the SPI line inside the PS. I want to use this SPI lines to transfer data and provide control to the another module. Thanks AMOL
  3. Hi I'd like to buy Digital Discovery to interface FPGA board to PC. As i saw the datasheet, It says that Digital Discovery has SPI read function. If the FPGA sends an SPI signal through Digital I / O, can the PC determine the SPI signal from the code and store the data? If you know, Please let me know.