Search the Community
Showing results for tags 'sma connector'.
The PModIA has two SMA connectors as the terminals between the impedance to be measured. These connectors apparently have a 50 Ohm impedance. Does this impedance need to be accounted for when taking impedance measurements using the board? I haven't found anything in the documentation mentioning this. Because there's two connectors, would the impedance be doubled to 100 Ohms? I figured when calibrating the board with a test resistor, I would have to add 100 ohms to whatever that resistor value is.
Hello everyone . I am looking for FPGA development boards that offers the following ports VGA PS/2 Two DB9 RS232 RJ45 i also need an SMA Connector and at least 1600K gates so Spartan 3E Starter Board is not an option for me, can anyone kindly advise me about the board I should go for ,and what Pmod modules should I purchase with it. Regards, Abdul Hafeez.