Search the Community

Showing results for tags 'slave'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Calendars

  • Community Calendar

Found 1 result

  1. Hello, I am attempting to communicate to a Pmod RF2: IEEE 802.15 RF Transceiver with a Basys3 board using the SPI protocol in VHDL. The microchip on the pmod is the MRF24J40. How do I identify the address of the MRF24J40? To my understanding, if I want to write/read a memory location on the MRF24J40, I need to send the address followed by the address of the specific memory location on the MRF24J40. Is it written on the microchip itself? The master and slave SPI modules that I am attempting to use are linked to this post. The documentation for the master and slave links are below. The specification sheets for the pmod and MRF24J40 are included as well. Master: https://eewiki.net/pages/viewpage.action?pageId=4096096#SerialPeripheralInterface(SPI)Master(VHDL)-Transactions Slave: https://eewiki.net/pages/viewpage.action?pageId=7569477 Pmod: https://www.digilentinc.com/Pmods/Digilent-Pmod_ Interface_Specification.pdf MRF24J40: http://ww1.microchip.com/downloads/en/DeviceDoc/39776C.pdf Thank you. spi_slave.vhd spi_master.vhd