Search the Community

Showing results for tags 'setup'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. I am trying to use a Pmod485 (P/N 410-310) to connect an Arduino (TTL) to a motor controller (RS485). I am only using 1 Pmod485 and I am assuming I do need to short JP1, is this done just by sliding the blue cap over both pin headers? Also, the IC block diagram shows 2 separate GND (GND1 and GND2) but the module only has 1 GND available on the pin header. Does this mean both GND on the IC are connected together? pmod_pmod_pmodrs485_rm.pdf
  2. The installer can be launched in silent mode form command prompt or batch script: > digilent.waveforms_v2.7.5.exe /S /AllUsers In order to use the local version of requirements, have these setups in a directory named "Kit" next to the installer: - WindowsInstaller http://download.microsoft.com/download/1/4/7/147ded26-931c-4daf-9095-ec7baf996f46/WindowsInstaller-KB893803-v2-x86.exe - VC runtime 9 (2008) x86 SP1 + MFC update http://www.microsoft.com/downloads/info.aspx?na=41&srcfamilyid=a821847e-4c44-45c0-9128-61c822bb3280&srcdisplaylang=en&u=http%3a%2f%2fdownload.microsoft.com
  3. I am unable to upload projects to my chipkit pro MX4 board using MPIDE. My code compiles, I have the correct board selected and comport. However when I try to upload my project to the board I get an error saying that it cannot connect to the comport and to shut down applications that are using it. Has anyone set up MPIDE and used the chipkit pro MX4 board?