Search the Community

Showing results for tags 'server'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. When I try to program my board after I generated the .bit/.bin files, i get the following error [Labtoolstcl 44-26] No hardware targets exist on the server [TCP:localhost:3121]Check to make sure the cable targets connected to this machine are properly connectedand powered up, then use the disconnect_hw_server and connect_hw_server commandsto re-register the hardware targets.it says no hardware exists on the server, even though my board is plugged in with the mode jumper in the JTAG position. I also tried reinstalling Vivado to make sure the cable drivers were installed.
  2. Hello, I have created a TCP server on Xilinx Zynq 7000 Zedboard and TCP client on MATLAB on host computer. Zedboard and the host computer are connected through the Ethernet. The client requests the connection to the server, SYN, SYNACK and ACK packets are delivered successfully and the connection is established. (Packets are monitored on wireshark on the host computer). Now, If the client keeps sending the data continuously to the server, then server receives the data and process them. BUT the server crashes if I take some time interval in sending the data. For example: If I send data from client to server at time 0, and I take a gap of 60 seconds and then try to send the data from client to server, then by this time the TCP server has crashed and it does not receive data.If I keep sending data continuously then it does not crash, but if I take some time sending the next data, then TCP crashes. can anyone suggest where I am going wrong I have been looking over the Internet to find solutions but any help/suggestions would be appreciated.Thanks
  3. good morning the example Atlys_AXI_Web_Server_Demo_v_1_02.zip doesn't work on ise design suite 14.7. for the compilation and the programmation of the boards it's ok i have the message autonegociate 100Mb/s on the console but no dialog with the computer on the network the Library is lwip best regards