Search the Community

Showing results for tags 's7'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I have been working on developing an I2c interface on the arty s7 board, and during one of my hardware tests, I noticed that my debug LED's had shut off. I went to resend my bit stream and noticed that my hardware manager was no longer connected to the device. Whenever I plug the device in, it is clear that I am getting power, as the done LED, the power LED, and the TX LED are all on. However, when I attempt to reset the device using either the reset or program button, no change occurs (that is, the strobing LED pattern does not commence as it has in the past). I have checked my device manager and found that the s7 is no longer connected, and have restarted my computer as well as unplugged and replugged the s7. My primary concern is that this may be a hardware issue, but I am unsure as to what I could have done to cause this. I have been running 3 3.3v pins from the arty to a teensy. Any advice would be helpful. Thanks, Micah