Search the Community

Showing results for tags 'rev4'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hi, I'm trying to manually set the RC1 and RC2 pins on port C but I'm only able to do so with PinMode(). I'm able to manually set any of the other pins on port C but I'm not sure why I can't for RC1/2. Any advice on how to enable these pins to be set manually would be greatly appreciated :)
  2. Hello digilent support team, i have got a problem with my nexys 4 board. After i connected the board to a external power supply of 5V the board is death. I connected the positive pol of the source with the positive pol of the sink and the negative pol with GND of the board. I found the schematic of the nexys 4 board and made some measurement on my death board. I measure 5V at PIN 12/13 of IC22 ADP2118 but i don't measure 3.3V at PIN 6 at IC18 ADM1086, in the schematic the name of this voltage is FT3V3. But I coundn't find the source of FT3V3 in the schematic. Can you give m