Search the Community
Showing results for tags 'raw data'.
Objective: Transmission of Non-MIPI camera sensor data (i.e. any monochrome sensor) using MIPI CSI-2 TX Controller Ip core from on one Arty7 Board to another Arty7 board as MIPI CSI-Rx system or any MIPI Receiver based Video processor. IP core Application: The Xilinx MIPI CSI-2 TX Controller implements camera sensor transmitter interface over MIPI D-PHY Interface. It can be used to bridge between non-MIPI camera sensors to MIPI based video processor. This Core provides combination of MIPI CSI-2 transmit controller and D-PHY interface. System Overview as per our understandi
Hi. I've tried to operate Pcam-5c at Zybo-Z7-zynq7020 using Xilinx Vivado tool. I refered to source code for Pcam-5c posted on github( https://github.com/Digilent/Zybo-Z7-20-pcam-5c/releases ). It operated successfully but I want to try again using other camera module instead of Pcam-5c. I have some problems in MIPI formatting data because Zybo7020 & Pcam-5c use RAW10 data but my camera module use RAW12 data. How can I use RAW12 format with Zybo-Z7-20 ?
Hi all, I am new to AD2 so this might be a trivial question. I have a project where i want to extract raw waveform data from AD2 and feed it to my program which is C/C++ and do my own processing on it. I need this to happen live when i am connected to the signal. As far as i have seen it is possible to save a captured signal as image or values statically but i need to to happen live. Is it possible to so this? Thanks in advance, Shabbir