Search the Community

Showing results for tags 'raspberry pi 3 b+'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. I am using a Windows 10 laptop to connect to a Raspberry PI 3 B+ (Raspbian OS) with LINX. I have managed to connect to the Target, but once connected, I try to install Labview but I always get the following message: " Installation failed. If this is the first time the installation has failed try again. If this error persists search, then post on the LabVIEW MakerHub forumsat labviewmakerhub.com/forums/linx. Target configuration updated." LOG: Connecting to target... Successfully connected to target. Successfully connected to the target. Target configuration updated. OS Version: 10.0 CPU: Systemd Version: Has Internet Access: True Device Type: Unknown Adding MakerHub feed... MakerHub Feed Already Exists Updating package index. This may take over 30 seconds depending on your internet speed... Ign:1 http://feeds.labviewmakerhub.com/debian binary/ InRelease Hit:2 http://archive.raspberrypi.org/debian buster InRelease Err:3 http://feeds.labviewmakerhub.com/debian binary/ Release 404 Not Found [IP: 54.86.245.246 80] Hit:4 http://raspbian.raspberrypi.org/raspbian buster InRelease Reading package lists... Installing LabVIEW... Reading package lists... Building dependency tree... Reading state information... Checking target status... Installation failed. If this is the first time the installation has failed try again. If this error persists search, then post on the LabVIEW MakerHub forumsat labviewmakerhub.com/forums/linx. Connecting to target... Can anyone please help? Any help is greatly appreciated.
  2. Managed to connect the laptop (windows 10) using LINX to the Raspberry PI 3B+ (Raspbian), but whenever I try to install Labview (2014 Home edition) to it, it fails. Worse, the Raspberry PI's also looses its ability to connect the internet with the WiFi Lan and cannot set it up, having to re-install the Raspbian again. Any help is GREATLY appreciated.