Search the Community

Showing results for tags 'quad'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I have been following this tutorial and have had no luck. I am uncertain about how to configure the QSPI IP, because the tutorial starts assuming that I have done that part successfully, so I am not even sure if this is the root of my problem. I have tried these two configurations of this IP, compiled them, and exported them to the SDK, and none of them solved the problem: I made sure JP4 is in the QSPI position. On step 3.1 in the tutorial, I can see that the FPGA is programmed successfully and I see the following output (since I chose not comment out the VERBOSE define as suggested in the tutorial): While programming the flash on step 4 I notice that my FPGA code is erased from the board (leds I had assigned to outputs turn off). Is that supposed to happen? At the end of the tutorial I get no "hello world" output on the terminal after resetting the board, though the FPGA does seem to program from the flash successfully, so that portion works, but I can't get the C-code to run from the flash. Here is the sdk_console_output.txt so you can see the steps I took in the sdk to program the board.