Search the Community

Showing results for tags 'protoboard'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. I'm getting a myProto Protoboard in the mail tomorrow, and I can't tell what the connector type is for the external power supply. All I can see is that there is a max of 17VDC. What connector is used here? And is there a supplied external power supply to wall power, or should I be purchasing one? Thanks!
  2. Hello. I recently bought a Digilent Arty FPGA dev board. I need to connect some 8-bit or 16-bit SRAM chips to the board and I have to determine what the best method would be, to bring out the ( 40, I believe ) data lines on the four 6x2-pin Pmod connectors on the side of the Arty and connect them to a solderless breadboard, preferably without any soldering involved in this process at all. I need access to the Arty's LEDs and buttons on the top so I don't really want to go with a stackable Arduino shield, which requires much soldering to attach a solderless breadboard, at least, soldering is required for the Arduino shields that I've seen. Well, after thinking about my problem and the requirements for the SRAM chips in my design, I thought of a way to easily connect my Arty to any old breadboard. I plan on buying a few Pmod extender cables, some Pmod 2x6 pin headers / gender-changers and some 12-pin Pmod to DIP adapters. I could plug two or three Pmod extension cables into my Arty, plug 6x2-pin DIP connectors onto the ends of the cables and then plug the cables into a breadboard of my choice. I've made up a list of things I'd need to buy from Digilent and I think that I need a few of these : http://store.digilentinc.com/2x6-pin-cable/ , this : http://store.digilentinc.com/2x6-pin-header-5-pack/ , a few of these : http://store.digilentinc.com/pmod-dip-dip-to-12-pin-pmod-adapter/ and finally just any solderless breadboard. I'm wondering if this is the easiest method with which one access all of the data GPIO lines exported by the FPGA via my Arty's Pmod connectors -- if I've missed something obvious or this question seems stupid, then please forgive me. Any suggestions or advice would be appreciated, Thanks, jdb2