Search the Community

Showing results for tags 'programming cable'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hi, First thing first. I am a starter in the fpga custom design. I have done few simple projects codes in Digilent virtex 5 board but now circumstances requires me to get more IO pins. I will, in this section mention first what I am planning (English is not my first language sorry for any errors). 1) I am using XC6SLX9 2) Route the VCCAUX, VCCINT, GND, 100MHZ single ended clk. 3) Route out the JTAG pins (namely TMS, TDO, TDI, TCK) 4) I am using ISE 14.7 5) 1) I just want to generate gate signals. In this section I shall lay out what help I want. 1) Is what I have done enough to program the spartan 6 device via JTAG? (I know it will be volatile) 2) Can I program it using the JTAG HS3 cable? (someone said that I need the platform cable to program and HS3 only works with series 7 ics, but platform cable would cost too much for me at this moment) 3) For a 14pins (7 pins in 2 row) JTAG connector, what other routing I need to consider from the FPGA (except the 4 JTAG pins mentioned in the previous section) . Any other help or information that I need is extremely acknowledged. FYI: I am also attaching an approximate final outcome that I want.
  2. thweight

    Hello Everyone!

    I just received my BASYS 3 board and everything is going normally for me. I can't seem to find which cable I need in order to program it from my PC. Anyone know the answer?