Search the Community

Showing results for tags 'program'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 4 results

  1. I have given Arty boards to some people, and now I need to update the SPI ROM. Is there something smaller than the fully Vivado and its HW manager for doing this? I would assume something that just connects to the USB and programs it the same way (with a bin file). Sorry if this has been covered before, but I cannot find it in the forums nor in the manual.
  2. Hi people, What I mean is that, can I write a program such that it can program the FPGA while executing? Thanks!
  3. Hi, Is it possible to program the Genesys 2 board using the xc3sprog tool? I've tried with many different cable types with no success. Thanks.
  4. Hi, I had no Problem to program the qspi from Vivado by following the guide from the resource center. But that only gives me the hardware configuration. I also need to Program the Microblaze from the SDK. In previous projects with the ISE tool I used the iMPACT tool from Xilinx, but that doesn't seem to be available!? What is the best and easiest way to do a full programming (hardware and microblaze software) from the SDK? I am using the Vivado 2015.3 WebPACK with a Nexys4-DDR Board. Thanks party-pansen