Search the Community

Showing results for tags 'preset'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Hej, I try to configure the zynq7 PS in vivado 19.2 but the used board Cora Z7 is not available in the "Presets List". see screen dump. The board is selectable when I set up a new project. I tried to import xps settings and addressed the file preset.xml directly from C:\Xilinx\Vivado\2019.2\data\boards\board_files\cora-z7-10\B.0 but "Current Preset: none" What to do to preset the zynq PS for Cora Z7?
  2. Hi there, Iam starting with your cora z7-10 board and I'm little confused with preset file mentioned few times on resource page. I am able to locate XDC master file but not preset file for PS. I am creating my own but I am not able to set voltage on MIO bank 501 to 1.0V as you have in description here on table 2.1 (second section) and I am missing signals like USB resetn... Can you point me to mentioned preset file for PS? Thanks a lot! have nice weekend! Joe
  3. OK... I've pored over the forums, and found many questions tangentially related to my topic, yet cannot figure out the answer to my question. I'm using the *original* Digilent Zybo board, i.e. it has a VGA port. I've used one personally for a while now, but I'm now doing a project at work on a new Zybo. I cannot, for the life of me, get the DDR to be configured to work properly. I have tried every which way... including a custom memory part but it is all to no avail. I tried to get around this by using OCM, and it works, but then I could not get the QSPI to flash with my execute