Search the Community

Showing results for tags 'pmu'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. mojs

    Z7 board upgrade PMU?

    Hi everyone. I am curios if there is a relatively simple modification I can do to increase available FPGA power, especially the 1V into the FPGA, on a Z7-20 board? Background, my problem is simple. I load a design into the Zynq that is expected to drain much more on the 1V supply then what the PMU inside the board can deliver, when loaded the LD13 led goes down almost instantly indicating that the supply rails can't keep up. This is easy to do, just try to use half of the Fabric at a decent frequency (200+MHz) and you will have run out of power. So I assume the PMU was dimensioned for the smaller FPGA on Z7-10 originally. Regards