Search the Community

Showing results for tags 'pmodusbuart'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Test and Measurement
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 3 results

  1. Greetings! I would like to share a CMod S6 System on a Chip (S6 SoC) design. This project is designed to demonstrate how capable a CMod-S6 can be, while also demonstrating a home-grown soft-core CPU: the Zip CPU. In particular, the S6 SoC project demonstrates: The ZipCPU (GCC and binutils support are provided elsewhere via the Zip CPU project) Several PMod's: PmodUSBUART, PmodAMP2, PmodKYPD, and the PmodCLS--all running at the same time even! A small multitasking home-grown operating system, the ZipOS. In the spirit of Free and Open Source, all of the source co
  2. Dear all I build a system EDK using option "Create a System for a Customer board" on Kintex7_1G_CML, as setup UART connection in system.ucf I found two documents that describes Follows the Digilent Pmod Interface Specification Type 4 : TXD connect to Pin 2, and RXD connects to pin 3 Follows to Pin 2 to RXD and Pin 3 to TXD However even i swap two pins together, but UART still does work, no line "Hello" displays on Terminator PC Any help, advise Thank so much Tuan Trong
  3. Hi, I am thinking of using the PmodUSBUART - USB to UART Interface, part #410-212P-KIT in my design. Can you tell me what pitch are the pins for J2. Is this a 0.1inch pitch header? Thanks Chris