Search the Community

Showing results for tags 'pic32'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 4 results

  1. Howdy. I have what I think is a fairly basic question: Which (non-FPGA) processor boards support Pmod modules? Is there any chance to see a table that shows each of the current ARM and PIC32 processor boards down a left-hand column and then the quantity of each of the Pmod ports (of each different configuration) on the middle of the chart? Thanks
  2. Hello everyone, PIC32MX and PIC32MZ base support has been merged in RIOT-OS. In addition, basic support for the chipKIT Wifire has also been merged. RIOT is a small operating systems for embedded devices with the following features: Multi-threading support, with a full stack for each thread Some POSIX compatibility network stack with IPv6 support Drivers for various sensors And many other things The current support for the chipKIT Wi-Fire is still very incomplete: only a small GPIO driver has been merged. I have written some drivers for SPI, I2C, Ran
  3. I'm trying to write a code that will display the character H in the left top corner when the potentiometer is fully counter-clockwise, H in the middle when potentiometer is halfway between ccw and cw, and finally H in the right top corner when potentiometer is fully clockwise. Though my code works, I used a for loop to iterate through all the LEDS before the place where I want to put the H character. I wanted to know how I can change the position of the column number of the Oled. Here's my code: #include<p32xxxx.h> #include<plib.h> #pragma config POSCMOD=HS, FNOSC = PRIPL
  4. I have had these microcontrollers from Digilent for some time but have never needed the Vref+ pin until now. From my understanding, it should be on the ADC or somewhere near it on the PIC32 pins. I have tried looking through the datasheets and have only found that pin42 on the UC32/IO-shield is the correct pin for the Vref+. I also tried calling and had recieved no help there. Can anyone help me locate the Vref+ pin as I am using this as the reference input to the micro-controller. The board is a PIC32MX340f512h