Search the Community

Showing results for tags 'pcie'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hey, In V4 version of the doc (and board?), http://digilentinc.com/Data/Products/NETFPGA-1G-CML/NetFPGA-1G-CML_rm_V4.pdf (currently linked on Digilent website), the pin constraints for pcie-rx3_p, pcie-tx3_p, pcie-rx3_n and pcie-tx3_n are wrong, as they are the same as pcie rx/tx port 2 (see first half of page 19 of aforementioned pdf). In V3, https://www.digilentinc.com/Data/Products/NETFPGA-1G-CML/NetFPGA-1G-CML_rm_V3.pdf (found via Google), I discovered what might be the correct values - it would be nice if someone could confirm them as being right (page 19).
  2. I tested the NetFPGA-1G-CML board with my laptop via a PCMCIA-to-PCIe adapter if it’s running. I use the PE4L-EC060A converter from Bplus company. My test is succesful on very short time. You will consume very short time than setting up NetFPGA within a desktop computer. The materials you need are listed below: SPB087 (ExpressCard 34 to 54 bracket): http://www.hwtools.net/Accessory/SPB087.html PE4L-EC060A: http://www.hwtools.net/Adapter/PE4L V2.1.html My host laptop model is HP-ProBook-6450b and I have to use a 34-to-54 PCMCIA bracket passive device. On the PE4L-EC060A board there are PCB notes layer how to configure the jumpers and switches. My switch configuration and fixed running with NetFPGA-1G-CML board configurations are SW1 PERST# Delay position:1-Disabled and SW2 PCIe card position: 2-3 (x2,4,8,16). (Because NetFPGA-1G-CML board PCIe interface is PCIe x4) No extra power supply needed. It’s very easy. And the jpegs are below too. If you need further assistance regarding this publication you can send an e-mail to kursat.gol@oeee.web.tr or go to www.oeee.web.tr my blog. Have develop your own open platform network with your mobile host PC and mobile NetFPGA !!! Note: I thank you to my wife Aysegul Kiraba Gol one more again for her trust and belief to my ambition.