Search the Community

Showing results for tags 'nexysa7'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I had left my board connected to my laptop and power to the board was abruptly cut off when the laptop died. I tried to connect the board to a different computer and realized that it no longer turned on. Though, the computer's device manager shows that something is plugged in. Yet, adept and vivado are unable to recognize that a device is connected - on vivado I was planning to restore the board to it's default setting using a .bin file but received the following error message: ERROR: [Labtools 27-2269] No devices detected on target localhost:3121/xilinx_tcf/Digilent/210292AA77E6A. Check cable connectivity and that the target board is powered up then use the disconnect_hw_server and connect_hw_server to re-register this hardware target. ERROR: [Common 17-39] 'open_hw_target' failed due to earlier err. I used a voltmeter to test the voltage across the on/off switch and was getting around 3.3V but now get 0.003V. When I tested the switches that control the on-board LEDS, the also produced around 0.003V. Please help.