Search the Community

Showing results for tags 'nexys 4 ubuntu vivado'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hello, I have Vivado 2014.4 installed on Ubuntu 12.04 (64bits). I have a Nexys 4 Digilent Board (Artix 7) connected to the PC through a USB cable but in the Hardware session I'm unable to connect to target. I get this error message: WARNING: [Labtoolstcl 44-26] No hardware targets exist on the server [localhost] Check to make sure the cable targets connected to this machine are properly connected and powered up, then use the disconnect_hw_server and connect_hw_server commands to re-register the hardware targets. Running the lsusb command in a terminal, the USB-UART IC of the board seems to be recognized: Bus 001 Device 007: ID 0403:6010 Future Technology Devices International, Ltd FT2232C Dual USB-UART/FIFO IC I also tried installing Adept but when I run the "djtgcfg enum" command I get: "No devices found". Any ideas? Thanks in advance.