Search the Community

Showing results for tags 'network shield'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 4 results

  1. I have at least 4 older chipKIT Max32s and a few Network shields for Ethernet and the CAN buses. Can I use the older Network shields on the newest Max32s from Digilent? Also, I will be creating my own shield soon, which will have 2 x CAN, 1 x RS485, at least one dsPIC for 2 x QEI communicating serially to the Max32, and use at least 4 PWMs, Are there differences in the shields? If I design a shield for the older chipKIT, will it work on the newest Max32? Is there a change log for the changes between the Max32s? It would be nice if the outside headers are in the same location and the pin-out is identical.
  2. Hello, I am working with the chipKIT Max32, chipKIT Network Shield, and ti / Stanford Analog SHIELD from Digilent. I need to be able to generate various analog signal remotely (Ethernet). I have not been successful using the Analog SHEILD with the Max32 (much less the addition of the Network Shield). However, using my Arduino Uno, I am able to generate a signal using the "passthrough" and "ramp" example with the Analog Shield. I would continue to use the Uno, however, I need the extra digital I/O the Max32 (Mega format) has to offer. Also, I have verified basic communication with Max32 using the "blink" example. 1) What is the probable cause of my failure with the Max32 versus the Uno? 2) What corrective action should I take? Boards in use: Max32 Rev E, Analog SHIELD Rev D, Network SHIELD Rev C Software: passthrough and ramp examples included with the Analog Shield library, Arduino IDE 1.6.13 Note: I had looked at using MPIDE with the chipKIT Max32, but the website for MPIDE recommended the most up version of the Arduino IDE. So, MPIDE is one option (of which I am aware) I have not tried, yet. Thank you for any assistance you can offer.
  3. Question from a customer: Can we use this same Network shield for the ChipKit Wi-Fire? Answer: Unfortunately, the network shield is not compatible to the chipKIT WiFire.
  4. The websites for the chipKIT Max32 and Network Shield both list multiple revisions of schematic (D vs E for the Max32; D vs F for the Network Shield). Both websites, however, only list a single orderable part number. What revision / version of hardware am I ordering? To add to the confusion, I called Digilent today and the sales gal confirmed with shipping that both units are only shipping revision C. ???