Search the Community

Showing results for tags 'mrf24'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. As already mentioned in your FAQ, there are some issues with noise/peaks on the oscilloscope channels of the OpenScope. In the example (OpenScope_Peaks.png) you can see distortions of up to 200mVpp. The test setup: Ch1: connected to DC1 @ 157mV Ch2: shorted to GND OpenScope is powered by a 5V USB power bank I noticed, that the distortions can be completely eliminated by touching the PCB antenna of the MRF24. It seems to work equally well if you tape down one of the insulated ground wires onto the PCB antenna. or keep protective earth close to the outer edge of the PCB antenna (e.g. between two layers of insulating tape).