Search the Community

Showing results for tags 'mplab x ide'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Dear All, I am new to programming with microcontrollers and I have to use the Digilent Pro MX7 kit for a project. I have had a look at the resources on the reference manual, but I am still struggling to configure the kit and compile a basic LED flashing program to it in MPLAB X IDE. Are there any basic tutorials available to help me with this? Kind Regards Sol
  2. I'm pretty confident I am following instructions to the letter but it's possible I am doing something wrong. But any assistance here would be great. MPLab X (5.20), XC32 (2.10), Arduino 1.8.10, Chipkit Library 2.10, Importer 1.0.6 (All the latest), Target Board is Pro MX 7. The latest importer states these versions should be acceptable because of the whole "or later" caveat. I've added photos showing I'm my directories (pretty sure they're all pointing to the correct location I'm trying to upload the Chipkit Wire - Master Reader .ino file. I select the Pro MX 7 in Arduino IDE, op
  3. I have purchased a uC32 Chipkit (with a Pic32MX340F512H). I have a PicKit3 for development. I was provided a blink.c example which I now have running. Can anyone provide an assembly language example? I am running MPLAB X IDE.