Search the Community

Showing results for tags 'motor'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 7 results

  1. Hi guys: I need know how create a Custom Command in LINX for read a encoder of two square pulses from the digital pins of Arduino in LabVIEW. Thanks.
  2. At the description of the Pmod Step it says that it can drive both motors simultaneously. I want to know if it can drive them with different number of steps on each motor. So the Pmod STEP will be like an 2 in 1 driver or it can only drive identical the motors.
  3. Although this isn't using a Digilent FPGA board, here is how to drive a low-cost stepper motor and to count the steps taken. It is using a 5V stepper motor, but if you have 12V motor & driver board it may also work for you. http://hamsterworks.co.nz/mediawiki/index.php/Stepper
  4. hello, i need to run and command a motor ( small engine, using my zedboard, please can you reference me a link on Diligent website, and please, there is another method to do this, i mean via other card like FMC ? if i will use a simple Pmod, just it, no other equipment ? thank you
  5. I'm trying to find a fairly low cost, low power motor with a built in encoder for the students in my mechatronics class. I came across this motor on the Digilent website: http://www.digilentinc.com/Products/Detail.cfm?NavPath=2,403,625&Prod=MT-MOTOR However, the datasheet at the bottom of the page is for the 12V and 24V version of this motor, so it is difficult for me to detemine if this motor will meet my needs. Additionally, I'm trying to teach my students to read datasheets, so having an accurate datasheet to perform interfacing comparisons and computations is important. Does anyone have the datasheet that actually matches the 6V version of this motor that is being sold? Thank you!
  6. I am new to all this. I want to run two dc motors but I want to start them after I press button btn1 and stop after btn2 is pressed. This is my first try. #include <MotorShield.h> // the setup routine runs once when you press reset: void setup() { // initialize serial communication at 9600 bits per second: Serial.begin(9600); } // the loop routine runs over and over again forever: void loop() { // read the input pin: int buttonState = readButton(btn1); // print out the state of the button: Serial.println(buttonState); delay(1); // delay in between reads for stability } it doesn't like bnt or readButton.
  7. Hi, where can I find out the pin out of the for motor / gearbox? https://www.digilentinc.com/Products/Detail.cfm?NavPath=2,403,625&Prod=MT-MOTOR