Search the Community

Showing results for tags 'low pass filter'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hi, I am trying to establish a lowpass filter to Audio Demo code of Nexys A7 board. I have implemented a filter however i hear just a noise. If you share your time, i will be happy. I have added the project which was generated by Vivado 2018.2. Vivado Project Best regards.
  2. I am designing LPF using FIR IP Core in receiver of Radio. My sampling frequency is 0.96M Hz and cutoff is 4K. I designed the FIR filter using Matlab and used the coefficients in vivado, FIR IP Core. My question is whats the relation between sampling frequency and clock frequency for single rate FIR filter? For 0.96 as sapling frequency and clock frequency my output signal is not getting filtered as shown in second pic. (Carry_d is input where op_dmod is filter output) If i increase the clock frequency to 09.6M (with input sampling 0.96M) the output is a clean sine wave but some sampl