Search the Community
Showing results for tags 'legacy'.
Found 4 results
-
Help getting valid 'Logger' readings (Analog Discovery Legacy)
MAK posted a question in Scopes & Instruments
I'm trying to take accurate readings using the "Logger" module in Waveforms 2015. When I power up a simple DC circuit with +5V, and use a DMM I get readings of ~4.44 volts. However when I run the data logger module, all of the readings are <100 mV. Shouldn't the logger be reading ~4.44 volts, or is there some configuration I am missing Thanks in advance! -
Hello, I'm a newbie using the Analog Discovery (Legacy), and attempting to run through a few experiments. When using the Power Source or "Supplies" tool in Waveforms 2015, all the directions and manuals show a dropdown menu where you can adjust the voltage (0-5V). The manual from Digilent's own website SPECIFICALLY regarding the Analog Discovery Legacy shows this as an option as well. I can't find any such option however in my program, it just isn't there. I should mention that I am powering the AD itself via USB from my laptop, but I don't think that is the issue as according to the status I am outputting ~5V via USB just fine, and the manual also shows the dropdown while being powered by USB. I also don't know what the little green bar underneath is supposed to represent, as it moves up only partially seemingly to random places when I turn on the "Master" enable, in case that it something to be concerned about. Any help is appreciated. Thanks!! P.S. Sorry for the re-post I realized I put this question outside the "Waveforms" Forum.
-
Hello folks, I'm a newbie using the Analog Discovery (Legacy), and attempting to run through a few experiments. When using the power source tool via Waveforms 2015, all the directions and manuals show a dropdown menu where you can adjust the voltage (0-5V). The manual from Digilent's own website SPECIFICALLY regarding the Analog Discovery Legacy shows this as an option as well. I can't find any such option however in my program. I should mention that I am powering the AD itself via USB from my laptop, but I don't think that is the issue as according to the status I am outputting ~5V via USB just fine. I also don't know what the little green bar underneath is supposed to represent, as it moves up only partially seemingly to random places when I turn on the "Master" enable. Any help is appreciated. Thanks!
-
Hello everyone . I am looking for FPGA development boards that offers the following ports VGA PS/2 Two DB9 RS232 RJ45 i also need an SMA Connector and at least 1600K gates so Spartan 3E Starter Board is not an option for me, can anyone kindly advise me about the board I should go for ,and what Pmod modules should I purchase with it. Regards, Abdul Hafeez.