Search the Community

Showing results for tags 'kernel'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 4 results

  1. Hello, I tried to Embedded Linux kernel build with Zedboard, and I refer to http://www.wmelectronic.at/PDFS/digilent/ZedBoard_GSwEL_Guide.pdf However, When I try this page, I faced something strange. https://github.com/Digilent/linux-digilent Because, This git hasn't include "digilent_zed_defconfig" What was wrong? I'm working with Ubuntu 16.04 LTS / Xilinx ISE 14.7 Webpack
  2. Hi, I am using Xilinx Zynq UltraScale+ MPSoC ZCU102 Evaluation Kit and I am newbie for using this board. I'm following this link to generate an interrupt using GPIO switches and turn off a led : http://www.wiki.xilinx.com/Linux+GPIO+Driver. The drivers works correctly and the led is heartbeating, when i check /proc/interrupts i get: ... 223: 0 0 0 0 GICv2 154 Level fd4c0000.dma 224: 0 0 0 0 xgpio 0 Edge sw14 233: 0 0 0 0 GICv2 97 Level xhci-hcd
  3. Hello everyone; I am trying to boot Linux on Zybo using this tutorial: http://www.instructables.com/id/Embedded-Linux-Tutorial-Zybo/?ALLSTEPS I have load Boot,bin, devicetree.dtb uImage and uramdisk.image intor fat32 partition of my 16 Gb sd card. size of uramdisk.image is around 5 Mb. when I boot the Linux, I have the problem like this, BAD DATA CRC h Do you have any experience on that ? is the size of kernel correct?
  4. I've een going through the Zybo Embedded Hands on Tutorial and I ------ - Cannot find zynq_ZYBO_config file for compiling UBOOT. It's not there in the master and master-next branch.... - Cannot find ramdisk Image on ZYBO webpage... - Cannot proceed further... IMHO the "tutorial" is not organized properly at all... Is anyone at Digilent maintaining / reviewing all these documents before putting them up on the internet ? Can anyone provide these files if they have ? Thank You....