Search the Community

Showing results for tags 'interrups'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I am trying to create an interrupt handler using Zynq. I am using the Zybo board and am using the Linux kernel from the following link: https://github.com/Xilinx/linux-xlnx.git. I have searched the Internet and I think I have everything set up properly but my handler never gets called in my driver. Here is my block design: ... and my interrupts set up in vivado: My dts file (attached here) contains the following: ps7_gpio_0: [email protected] { #gpio-cells = <2>; clocks = <&clkc 42>; compatible = "xlnx,zynq-gpio-1.0"; emio-gpio-width = <64>