Search the Community

Showing results for tags 'inout declartion'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hi, I need help to initialise and implement an inout port in BASYS 2(Spartan 3E) FPGA board. I tried using IOBUF and assigned that port to B6 or A9 or C6.I couldn't get the result. Without using the IOBUF, i am getting the desired signal pattern as output but in milli volt range. And i'm not sure whether i able to recive or not with out using the IOBUF since I could not test it.. I want to implement the I2C protocol, so the sda line should be INOUT, which I cant figure out...Should I use any specific PIn in Pmods of Basys 2 as Inout port.... Please help me with this... Thanks in Advance Athul