Search the Community

Showing results for tags 'iic'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Hello, I am trying to initialize the ADV7611 Chip of the Digilent FMC-HDMI add-on Board. But I can't find the needed addresses for it (this doesn't help). I am using the xiic.h Driver from xilinx. The initalization of ADV7511 Chip of the zc702 was successfully. Have anyone a idea?? I am using the zc702 and the digilent FMC-HDMI Card.
  2. david.600

    Zybo I2c Master

    Hi, I have the Zybo Zynq 7000 board (Z-7010). I also have a Ti Msp430G2 launchpad. I need the Zybo to be the Master I2c , send request data from the Ti Chip. In Zybo i'm Using the I2c_0 Built in controller on the ps, i've tried the following Examples with no success(test failed Everytime): xiicps_polled_master_example.c xiicps_slave_monitor_example.c then i tried to to troubleshoot the problem, i'v used the xiicps_polled_slave_example.c and on the Ti Chip i used the wire library, as I2c Master and a c program that Scans Addresses - this works Therefor all the connections and vivado config are fine. How can find a working Master Program for zybo?
  3. david.600

    Zybo I2C

    Hi, I have the Zybo Zynq 7000 board (Z-7010). I want to receive data from Multiple Devices via I2C protocol. In the PS there are 2 I2C Controllers. The Steps i made so far: 1) In vivado i created the ip : Zynq7 processing system. 2) i'v enables the I2C 0 controller and routed it to Emio. at this point i need 2 pins: clock and data, but instead i have 6 pins: where should i connect the pins? after Exploring this issue online i saw another option : using the Axi_IIc ip, With the same problem: