Search the Community

Showing results for tags 'hb3'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hi, I wonder how fast I can trigger the HB3 Pmod (H-Bridge). Neither the datasheet or schematic give the references for its transistors and FETs. Is there somewhere I can find this information? Datasheet: https://reference.digilentinc.com/reference/pmod/pmodhb3/reference-manual Schematic: https://reference.digilentinc.com/_media/reference/pmod/pmodhb3/pmodhb3_sch.pdf
  2. Hello again I was looking at doing a servo project and bought a GWS-S03N servo motor and the HB3 PMOD. Looking at various sites, I have not seen anyone using the HB3 to control a servo. Is the only purpose of the HB3 to allow higher voltages to the servo motor than the Basys2 can output? It appears that pulse control is still coming directly from the FPGA board. So, if I used a higher voltage to the PMOD and motor, is there any chance of damaging the FPGA by connecting it directly to the control line of the servo? Is the HB3 more (or only) intended for driving standard DC motors and not servo motors? thanks