Search the Community

Showing results for tags 'fmc connector'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions


  • Community Calendar

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 2 results

  1. hello, i'm new born baby in embedded system. I want to establish a communication between ADC Board to Zedboard(PL-section-xc7z020) via LPC-FMC connector. please tell me lpc fmc pin out and how those pins connected to PL(FPGA) Section of zynq (like any diagram). please help me, Thank you.
  2. Hi, I am using currently Genesys 2 board to interface my image sensor board. I want to connect image sensor board through the FMC connector of Genesys 2 board. Image sensor board is interfaced with C)N/FMC-ASP-134488. I have 12 timing signal pins in the sensor board, which are assigned to connect at serially pin no. K17, K20, K23, K25,K26,K28,K29,K31,K32,K34,K35,K38. (The pins are marked at attached schematic file of Genesys 2). My problem is when I am going to assign K17,K31,K32,K34,K35,K38 pins in the XDC file of the Genesys 2, I did not find these pins in the XDC file. Besides, I also tried to assign pins by RTL analysis (Elaborated design). But, in there these pins are also showing as invalid package pin. (the . XDC file is also attached here) So, how can I assign these pins in XDC file? OR it can not be used as I/O pin? Besides, I have 14-bit data output from the sensor board. Can I connect these 14-bit data pins directly to the FMC connector of the Genesys 2? I saw in the schematic of FMC connector I/O pins are differential. Is it will be a problem? Any suggestion will be appreciated. Thanks. Genesys2_H.xdc