Search the Community

Showing results for tags 'external clock'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Hello everyone, I need suggestion about following topic: 1) I want to use an external oscillator 54 MHZ. And I want to take input this clock by FMC connector HA/LA pair (3.3 V) of genesys2 board. Is it will be ok? 2) The fixed oscillator 200 MHZ in Genesys2 is differential. I am producing my master clock for my design by MMCM. How can I have the minimum jitter? Any suggestion will be very helpful. Thank you Rappy Saha
  2. I soldered on an external 16 MHz clock to the PMod IA, it was sending data out, and the oscillator was clocking at 16 MHz but there was no fluctuation in sensor impedance. I an worried I might have over heated the board or oscillator. What type of solder is used on the solder pads of this board? Katy
  3. Hi, I need to input a 50 ome 1 volt sine wave to Max32 under External Clock mode. Does Max32 only take square waves? Will this do any damage to my equipment please? Thanks, Jack