Search the Community

Showing results for tags 'ee'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. In case your Electronics Explorer board is not detected by WaveForms application try to do the followings: 1. Check if it is properly supplied with 12V and the Red Power LED is on? The USB controller is powered by this supply, connecting only the USB cable is not suffice. 2. Check if the Yellow USB LED is on when the USB cable is connected? Otherwise, try to use another micro USB cable and computer plug. 3. Remove the board supply, wait a minute then connect it back. Do this, to make sure that all the internal circuits are reset.