Search the Community

Showing results for tags 'duty ratio'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Test and Measurement
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I am using a Nexys-4 DDR board which has an internal clock of 100 MHz frequency. I am using clocking wizard to generate a pulse of 6.78 MHz and duty ratio of 0.3. I am getting the correct result in simulations but when I observe the output on oscilloscope I do not see a proper pulse. It does not have sharp edges. I get a proper output for lower frequencies. I am unable to find out what is the reason behind this. I am using a 200 MHz bandwidth DSO and an x10 probe for measuring the output. Thanks, Yogita