Search the Community

Showing results for tags 'done led'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hello everyone! I just install a NetFPGA-SUME and I am not sure if it is ok. I followed the getting started guide in https://github.com/NetFPGA/NetFPGA-SUME-public/wiki/Getting-Started-Guide, however, something went wrong apparently... In the Section IV: NetFPGA-SUME First Power Up, I followed the steps, but, after turning on the power switch (SW1) it says I should see Power LED (LD10) and DONE LED (LD4) turn on immediately, however I only see the Power LED (LD10) on... in red. The DONE LED is off. In the next step... When I connect USB to my computer I can see a new USB serial device attached [ 13.194737] usb 3-1: FTDI USB Serial Device converter now attached to ttyUSB1 However, when I try to connect, terminal does not respond (I'm using putty to connect /dev/ttyUSB1). Any clue about what is happening? I tried it with the card connect to my server PCI and also stand alone. Also connecting 2x4 and 2x3 PCI express auxiliary power connectors. Thank you in advaned!