Search the Community

Showing results for tags 'dmc60c'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. opethmc

    DMC60c CAN Bus

    I am looking at the DMC60c CAN protocol guide and also the software API reference manual. What are the API numbers needed in the CAN message to communicate with the DMC60c. For example if I wanted to send a voltage command using the function driveVoltage, what should go in the API field (Byte 1) of the message identifier? Thanks, matt
  2. Close full duty cycle (93% in attached images) the DMC60 pulses through zero to -12V and upon trying to recover causes an over voltage failure on the power supply. This happens unloaded and with a small load of 4Amps. Anyone else have this issue? Cheers, matt The onset of this behavior can be seen as you increase the duty cycle you get an occasional incorrect extra pulse as shown in the following figure