Search the Community
Showing results for tags 'cora z7'.
I am trying to use a DAQ to analyze I2C, SPI, and UART signals and then classify them, so they have to be the actual output signals from the Cora Z7 board. However, I am limited due to the project itself to use only the General Purpose I/O pins (IO0-IOA(IO42)). Is it possible to funnel the SPI, I2C, and UARt signals through these pins, or can you only use the specified pins, such as SDA/SCL, MISO/MOSI, or the USB UART bridge to do this?
Hello everyone, I am trying to control the output of the LEDs of my board with MIO, as shown in this example. The thing is that looking at the schematic of my Cora Z7 board, the LEDs do not appear in the MIO bank. Is it at all posssible that the board does not offer the possibility to configure MIO rgb leds as outputs? Thank you and have a nice day.
Hi there, Iam starting with your cora z7-10 board and I'm little confused with preset file mentioned few times on resource page. I am able to locate XDC master file but not preset file for PS. I am creating my own but I am not able to set voltage on MIO bank 501 to 1.0V as you have in description here on table 2.1 (second section) and I am missing signals like USB resetn... Can you point me to mentioned preset file for PS? Thanks a lot! have nice weekend! Joe