Search the Community

Showing results for tags 'case'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Test and Measurement
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Hi All: I'm fairly new to both Verilog and the Basys3 board. I'm working thru a 'self education' course. I'm having a problem with the following module. I could use any answers/advice I can get. The module, as posted (below) is processed by Vivado properly, loads into the Basys3 board and runs as expected with the LED blinking at a frequency of .7451 Hz. No problems. The example I'm working thru then threw out a 'challenge' of changing the frequency of the blinking LED based on the positions of two switches [1:0]. 1. I added in the additional input - input [1:0] sw
  2. Hello, My name is Simeon, I am postdoc at Purdue University. I'd like to use Arduino Uno and the Analog Shield for a quantum optics application. In a general effort to keep the setup organized and protect parts from damage, I enclose all PCB electronics into boxes or cases. So far, I have found all boxes and cases I need at DigiKey. However, for the {Arduino + Analog Shield} assembly, I have failed to find commercially available boxes with the correct dimensions, despite spending two hours looking for it. I called Digilent Customer Service, but they could not help me either. All I need is
  3. Hi. I have used combination of case and i-else statements. Now the problem is that first case executes successfully but second case never executes. While synthesizing on xilinx, it gives me an error saying that "case condition never applies". Does anybody know what is the problem? Thanks Saad