Search the Community

Showing results for tags 'camera sensor'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Test and Measurement
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. so i created this project , to display the video from camera OV7670 through VGA on my Zedboard , only using the PL part , the synthesis runs good but i when i try to generate the bitstream i get these errors that i can't seem to understand : error 1 : [Place 30-574] Poor placement for routing between an IO pin and BUFG. If this sub optimal condition is acceptable for this design, you may use the CLOCK_DEDICATED_ROUTE constraint in the .xdc file to demote this message to a WARNING. However, the use of this override is highly discouraged. These examples can be used directly in the .xdc fil
  2. Hi there, I'm new to the world of FPGAs, and was able to get my hands on the aforementioned Zedboard. I wanted to hook up a camera module to it for some real time processing stuff but I can't seem to find a suitable module. I've looked up PCAM-5c but it isn't compatible with my board although I did find some TerAsic although I'm not sure if they'll work or not. Any thoughts or recommendations?
  3. I am working on image processing project. I need to provide a monochrome image signal (8 bit per pixel) to my Zybo board. Also the image size, that I supply to the board should be a power of 2. I need to know, which camera sensors and FMC boards can I use with the ZYBO board.