Search the Community

Showing results for tags 'block memory generator 8.3'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hi, I am using block memory generator 8.3 in vivado16.2. I am using to store my image sensor data. The resolution of the sensor is 1280*1024(=1310720). And each pixel contains 16-bit. Parameters I am using: Interface type: Native, Memory type: Simple Dual port RAM. PORT A is used for writing the pixels into the memory block. PORT B is used for reading out. Port A Width: 16 Range: 1 to 4608 bits (as each pixel has 16 bit) Port A Depth: 1310720 Range: 2 to 1048576 ( but this value exceed the range) So, I am thinking to write two pixels into the memory at a time so that I can reduce the Depth at half. Port A Width: 32 Range: 1 to 4608 bits Port A Depth: 655360 Range: 2 to 1048576 But it gave me some collision error which is shown in the attached image. But, I gave the value within the range. How can I allocate memory for my case? And what is the reason behind this error? Any suggestion will be appreciated. Thank you.