Search the Community

Showing results for tags 'beagleboneblack'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Joined

  • Start

    End

Group

AIM

MSN

Website URL

ICQ

Yahoo

Jabber

Skype

Location

Interests

Found 1 result

  1. adithya76
    Hi, Following the tutorials, I was able to install labview and linx. I had developed a program, and it was running quite well. But whenever I turn my computer off and on, beaglebone fails to connect. In the sense, I'm able to connect to the beaglebone through the Linx target configuration and I can even ssh using putty. But when I go into my project and try and run the VI on BBB, it regularly pops up the error saying "Failed to connect to Target". I have vigourosly searched the entire linx forum for such an issue. And have tried everything that has been suggested but to no avail. My