Search the Community

Showing results for tags 'axi intc'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Test and Measurement
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hello, I checked the tutorials and read the pdf-s on the AXI Interrupt controller. However, i could use come clarification about a couple of things. In Microblaze advanced configuration there's an option to set interrupts to NONE/NORMAL/FAST, or leave it in AUTO mode. Is this setting linked to the AXI interrupt controller creation process? I mean if it run Block Automation, and enable Interrupt Controller, then AXI Interrupt Controller IP is created, but the setting doesn't change in the microblaze settings (for example it stays AUTO/NONE). Does that mean if i want a normal