Search the Community

Showing results for tags 'analogread'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hello and thanks for taking the time to read my question. I'm hoping to use the ADC functionality of the chipkituC32 but I have some questions. As I understand it, when I write the command Input = analogRead(A3) I should get an interger number 1023 /3.3 = x . However when I have no input into the A3 port, I get the constant number 788. How do I do the correct conversion? When I was sending in a DC voltage of 2 V I was getting alternating numbers between 600 and 1023 which make no sense. Also, I cannot find in the datasheet, what is the frequency to read in a signal? I found somewhere online that it was only 10kHz. That seems incredibly low. IS the read frequency for digital signals higher? If I have a separate ADC and send a digital signal could I speed this up? Thanks again