Search the Community

Showing results for tags '7segment'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions


  • Community Calendar

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 3 results

  1. Hi, We can see two dots on 7 segment display which usually present second in clock configuration. However, their pins are not defined in constraints file. I don't have much hope cause it seems the display has 12 pins (8 digit, 4 display). Can we use those dots? If so which pins are they tied to? Thanks in advance. Bora
  2. ulvarg

    Bays3 Programming Issue

    Hi, Ever since I programmed my Basys3 board via JTAG for the first time, I noticed that the 7-segment displays would stay slightly on despite not using them in my projects. Is this type of behavior to be expected? If not, does anyone know how to overcome this issue? Thank you.
  3. I am able to program my Nexys 3 board but it seems like when I power cycle it the program is lost and it goes back to the pre-loaded configuration that says "pass" on the 7 segment display. I can then load the program again and it works. What is the expected behavior? Does the FPGA have to programmed every time it starts? Is this a jumper setting I need to change to get it to maintain its state after power cycle? Thanks.